The cutting speed of photovoltaic support is closely related to the production efficiency of the factory, so what reasons will affect the cutting speed of solar photovoltaic support?

In terms of cutting speed, the cutting speed of solar photovoltaic support corresponds to its combustion speed in oxygen. In actual production, the speed of the cutting nozzle should be adjusted according to the following aspects:

1. Performance parameters;

2. Gas type and purity;

3. Material and thickness of photovoltaic support.

Its cutting speed directly affects the stability of the cutting process and the quality of the cutting section.

If you want to artificially increase the cutting speed of solar photovoltaic support to improve production efficiency and slow down the cutting speed to improve the quality of cutting section, it will only make the quality of cutting section worse and have no other benefits.

Excessive cutting speed will cause quality defects such as depression and slag hanging on the cutting section, which may cause cutting interruption in serious cases; Too slow cutting speed will cause the upper edge of the incision to melt and collapse, the lower edge to produce rounded corners, and the lower half of the cutting section to have water flushing deep grooves and pits, etc.

Therefore, when we produce solar photovoltaic supports, we must produce according to the standard operation steps, so as to improve the production efficiency and ensure the quality at the same time.